Overview:

The Ingenico iPP350 EMV card reader is programmed to connect to your local area network (LAN) via DHCP by default. Should you wish to configure a static IP directly to the device, follow these steps:

  1. Reboot the card reader by holding down the Yellow and # keys until the device resets.
  2. Wait for the boot menu to appear (see the image below) and enter 2634 followed by the Green key.
  3. Press the F key when prompted, this will take you to the administrator menu.
  4. Press the 3 key to select the TDA menu.
  5. Press the 0 key to select the Configuration menu.
  6. Press the 0 key again to access the Communication sub-menu.
  7. Press the 2 key to select Ethernet Settings
  8. Press the 3 key to select the IP Address sub-menu
  9. use the numeric keypad to entire the desired static IP address provided by your router.
  10. Press the Green Key to save your changes and repeat step 1. to rest your device.


    You should now see your static IP address appear on the boot menu. Be sure to also enter this IP address into the ACME Sales Configuration menu if you have not done so already.