Follow these steps to program your Ingenico Mobile card to a local Wi-Fi network.


1.   When the device powers on and displays the splash screen (refer to the image
below), do the following:
a. On the keypad, press the digits 2634.
b. Press Enter (Green button).

2. Press the F button.
    The Functions screen opens.
3. Press 0 on the keypad to enter 0-TELIUM MANAGER.
4. Press 3 on the keypad to enter 3-Initialization.
5. Press 2 on the keypad to enter 2-Hardware.
6. Press 5 on the keypad to enter 5-Wi-Fi.
7. Press 2 on the keypad to enter 2-Scan network.
    The card reader scans for available networks and displays them.
Note: If you do not see the available networks, press the Cancel button (Red  
    button) until you see the Press F for menu message, and start over from Step 2 of
    this procedure.
8. Scroll and select the network you wish to connect (using F2 or F3 keys and the
Green button).
9.  Select the Security Type as HOME SECURITY.
10. Enter the WiFi Password.
Tip: To enter your password:
- Use the F1 and F4 keys to move left and right.
- Use the F2 and F3 keys to move down and up.
       - Press the Green button on the keypad to select the highlighted character.
11. After you enter your password, scroll to (using F1, F2, F3, or F4 keys) and highlight
the Green button on your card reader display and press the Green button on the
     keypad.        
The password is saved.
12. Enter 20 as the Priority and press the Green button on the keypad.
You have successfully configured the WiFi.
 13. Press the Cancel button (Red Button) until to see the Press F for menu message.
If your card reader is connected to the network, you will see the network the card reader is connected to and the signal strength.
Note: Be sure to reboot the card reader by pressing the # and yellow keys to get out of the Admin menu and send the card reader back to the "This Lane Closed" screen before trying to connect with the ACME Sales application.