When in “Auto re-connect Mode”, the Epson TM-T88V will automatically reconnect to Bluetooth when the connection is interrupted. To determine if your Epson TM-T88V is currently set to auto re-connect you must obtain a status sheet:

  1. Turn the Epson TM-T88V off.

  2. Press and hold the Feed button.

  3. Turn the printer on while holding down the Feed button until printing starts.

  4. Press Feed again to exit.

  5. The following status sheet should print:

 

 

If “Auto re-connect” is DISABLED, perform the following:

  1. Turn Printer off.
  2. Locate the button on the Bluetooth Interface Card on the rear of the printer.
  3. While holding in the Push button, turn the printer on. Release the button when printing starts.
  4. Press the Push button twice.
  5. Press and hold the button again until printing starts. The printer will start printing Bluetooth setting instructions.
  6. Press the Push button once.
  7. Press and hold the button again until printing starts. The printer will start printing Auto re-connect iOS instructions.
  8. Press the Push button once.
  9. Press and hold the button again until printing starts. The printer will print the selected setting value (enable/disable).
  10. The printer will start printing the Wireless Module Setup instructions.
  11. Setting is complete. Power cycle the device.